Whats going on here?

[tode1]

Hi iv obtained my fuel map on my Ecutek 3. Car is a 03 STi running Fp green, standard pinks/ walbro pump etc

why do I have two 0.02 engine load columns running the same target AFR's ???? Also, Shouldnt it be targetting stoich = 14.7 ?

Iv done some data logging and im getting negative knock correction at low revs, and then positive all the way up. My advance multiplier stays at 16 the whole way

[ev8siv3]

You should be looking at your Timing Maps if you're getting knock at low rpms. Post that Map up, the fuel looks fine. When does that turbo kick in?

[NeverLies]

Post your complete dump, will be easier for us to help you