XML definitions for a EU 2002 STI AG820-2591

[scotty]

all is in the title, if someone has it, i am very interested in!
Thanks

[Nemis]

can you upload an ecu image of an ag820? thank you

[scotty]

i am actually waiting for my Openport 1.2 to come but as soon as i'll have it, i will put all i can here!

maybe i'll try with my SSM cable before... wait and see.

[scotty]

i've just tried ti get it with ecuflash but enable to do it...

for this version do i have to put a jumper on or just the green connectors?

at the beginning ecuflash doesn't purpose me my car version and after here what happens:
[00:28:59.561] error loading FTD2XX.DLL
[00:29:28.763] denso02_bootloader_cmd_start
[00:29:29.995] denso02_bootloader_cmd_start
[00:29:31.226] denso02_bootloader_cmd_start
[00:29:32.458] denso02_bootloader_cmd_start
[00:29:33.690] denso02_bootloader_cmd_start
[00:29:34.101] kernel get version
[00:30:41.217] ssm2_init
[00:30:41.417] ssm2_init
[00:30:41.618] ssm2_init
[00:30:41.818] ssm2_init
[00:30:42.018] ssm2_init
[00:30:42.218] ssm2_init
[00:30:42.419] ssm2_init
[00:30:42.619] ssm2_init
[00:30:42.819] ssm2_init
[00:30:43.020] ssm2_init
[00:30:43.370] kernel get version
[00:30:43.871] validating denso kernel ram area addr: FFFF6000 len: 0008
and the an error message

any idea?

[cboles]

Do you have the correct COM port selected?

[scotty]

it's the same one that i use for ecuexplorer which is working fine,
could it be a problem of "jumpers" like here?
http://forums.openecu.org/viewtopic.php?p=4714

i wanted to know if there's some risk by putting the jumpers (or one(blue/white) i have ordered the both ) on my car and try to read the ecu..?

Is it a problem if my car isn't in the list at the beggining of the soft (i selected 2004 STI because of it)?
thanks

[FrSTi]

it's the same one that i use for ecuexplorer which is working fine,
could it be a problem of "jumpers" like here?
http://forums.openecu.org/viewtopic.php?p=4714

i wanted to know if there's some risk by putting the jumpers (or one(blue/white) i have ordered the both ) on my car and try to read the ecu..?

Is it a problem if my car isn't in the list at the beggining of the soft (i selected 2004 STI because of it)?
thanks

Dadam,

You have to install the jumper to write into you Ecu.
Connect the 2 plugs available inside the 3 plugs white connector under your dash, they're close to the greens.

For your car, you must select the WRX 2002-2003 method.
2004 will not make it

If you're not 100% sure about what you are doing, send me a PM

[scotty]

so i have it since a fews days now...
i had to put the jumper on to read the ecu...

[Nemis]

4 kb only ?

[NeverLies]

4 kb as this is the TPU and not the CPU dump

[scotty]

i've uploaded the wrong one
What is that one in fact?

So here is the good one!

[Nemis]

tank's a lot.

from Tari site we have:
Revision: A4RG060Q (STI Type UK 01/02 - ag820 2591)
---- 3D MAPS ----
0x0 (0) : Maximum Wastegate Duty (Auto)
0x0 (0) : Maximum Wastegate Duty (Manual)
0x0 (0) : Target Boost Levels (Auto)
0x0 (0) : Target Boost Levels (Manual)
0x238F1 (145649) : Initial Wastegate Duty (Auto)
0x0 (0) : Initial Wastegate Duty (Manual)
0x237BB (145339) : Maximum Wastegate Duty (Auto)
0x0 (0) : Maximum Wastegate Duty (Manual)
0x2370D (145165) : Target Boost Levels (Auto)
0x2372E (145198) : Target Boost Levels (Manual)
0x0 (0) : Maximum Wastegate Duty - Secondary
0x0 (0) : Initial Wastegate Duty - Secondary
0x213C9 (136137) : Fuel Map (High Octane)
0x21697 (136855) : Fuel Map (Low Octane)
0x21CCC (138444) : Ignition Base Map
0x2223B (139835) : Ignition Correction Map
0x23231 (143921) : VVT - Intake Cam Advance Angle
---- 2D MAPS ----
0x23841 (145473) : Wastegate Duty Compensation - Primary (Atmospheric Pressure)
0x2384B (145483) : Wastegate Duty Compensation - Primary (Air Intake Temperature)
0x2385F (145503) : Wastegate Duty Compensation - Primary (Coolant Temperature)
0x0 (0) : Wastegate Duty Compensation - Secondary (Atmospheric Pressure)
0x0 (0) : Wastegate Duty Compensation - Secondary (Air Intake Temperature)
0x0 (0) : Turbo Dynamics - Proportional Burst
0x2378A (145290) : Turbo Dynamics - Proportional Continuous
0x238C4 (145604) : Turbo Dynamics - Integral Positive
0x2389E (145566) : Turbo Dynamics - Integral Negative
0x0 (0) : Boost Pressure Compensation (Atmospheric Pressure)
0x23975 (145781) : Boost Pressure Compensation (Coolant Temperature)
0x21A0E (137742) : Boost Limit
0x20089 (131209) : Mass Air Flow Sensor Scaling
0x0 (0) : Mass Air Flow Sensor Scaling
0x23EE4 (147172) : CEL Threshold (Boost Solenoid)
---- DATA MAPS ----
0x20000 (131072) : Rom Revision + Calibration ID
0x219DE (137694) : Rev Limit
0x2208F (139407) : Rev Limit Ignition Retard
0x2121B (135707) : Fuel Map Switch Threshold (Advance Multiplier)
0x223A3 (140195) : Knock Learning Range - Engine Load
0x223B3 (140211) : Knock Learning Range - Engine Speed
0x0 (0) : Turbo Dynamics - Minimum RPM
0x0 (0) : Turbo Dynamics - Minimum RPM
0x23873 (145523) : Advance Multiplier (Boost Disable)
0x23874 (145524) : Advance Multiplier (Boost Enable)
0x23875 (145525) : Turbo Dynamics - Minimum Boost
0x0 (0) : Turbo Dynamics - Minimum Boost
0x23877 (145527) : Minimum Turbo Dynamics Integral
0x23879 (145529) : Maximum Turbo Dynamics Integral
0x0 (0) : Speed Limiter (Boost)
0x20A0A (133642) : Injector Flow Scaling
0x23D72 (146802) : CEL Threshold - Mass Air Flow Sensor
0x2387F (145535) : Per Gear Compensation - Maximum Speed
0x23881 (145537) : Per Gear Boost Compensation (Manual)
0x23886 (145542) : Per Gear Boost Compensation (Auto)
0x0 (0) : Per Gear Wastegate Compensation
0x0 (0) : Intercooler Autowash Threshold - Coolant Temperature
0x0 (0) : Intercooler Autowash Threshold - Engine Speed
0x0 (0) : Intercooler Autowash Threshold - Boost
0x0 (0) : Intercooler Autowash Threshold - Vehicle Speed
0x0 (0) : Intercooler Autowash Threshold - Intake Air Temperature
0x23B3D (146237) : Select Monitor ID
0x219FF (137727) : Speed Limiter
0x2235C (140124) : Advance Multiplier (Initial)
0x2235D (140125) : Coarse Ignition Learning Range (Engine Speed)
0x22365 (140133) : Coarse Ignition Learning Range (Engine Load)
0x223DE (140254) : Fine Ignition Learning Range (Engine Speed)
0x223E6 (140262) : Fine Ignition Learning Range (Engine Load)
0x22397 (140183) : Knock Detection Range (Engine Speed)
0x2239F (140191) : Knock Detection (Minimum Load)
0x0 (0) : Idle Control Limits (AirCon On/Off)
0x0 (0) : Ignition Control Limits
0x21183 (135555) : Closed Loop Threshold - Minimum Coolant Temperature
0x21185 (135557) : Closed Loop Threshold - Maximum Engine Speed
0x21189 (135561) : Closed Loop Threshold (Auto - High Altitude) - Maximum Throttle %
0x2118B (135563) : Closed Loop Threshold (Auto - Sea Level) - Maximum Throttle %
0x2118D (135565) : Closed Loop Threshold - Maximum Throttle %
0x0 (0) : Closed Loop Threshold - Maximum Throttle %
0x21191 (135569) : Closed Loop Threshold (Maximum Vehicle Speed)
0x21193 (135571) : Closed Loop Threshold (Maximum EGT)
0x227BE (141246) : Idle Speed Minimum (Manual) - Air Con
0x227C0 (141248) : Idle Speed Minimum (Auto) - Air Con
0x22A20 (141856) : Idle Speed Minimum (Manual) - High Amps
0x22A16 (141846) : Idle Speed Minimum (Auto) - High Amps
0x22A22 (141858) : Idle Speed Minimum (Manual) - Startup
0x22A1A (141850) : Idle Speed Minimum (Auto) - Startup

so im looking hot do do xml definition from this table and add missing map

[scotty]

the xml definitions i had with xml write v6 is very more complete than that!
I have more than 160 differents maps in 1D, 2D and 3D with ecuflash 1.27

have i made something wrong?
I also have a lot of with enginuity or ecuedit...

[FrSTi]

the xml definitions i had with xml write v6 is very more complete than that!
I have more than 160 differents maps in 1D, 2D and 3D with ecuflash 1.27

have i made something wrong?
I also have a lot of with enginuity or ecuedit...

Nothing wrong, you're fine with that

[Nemis]

the xml definitions i had with xml write v6 is very more complete than that!
I have more than 160 differents maps in 1D, 2D and 3D with ecuflash 1.27

have i made something wrong?
I also have a lot of with enginuity or ecuedit...

i have ecuflash 1,27 but don't have map of this rom,it ask me what is this rom, maybe i have do some error