Evo6 EM2557-00 - RA 420996 EVO 6 Ralliart

[AIK]

ECU Group = EVO 5/6 Ralliart Group.

Is it possible to read this ROM by EcuFlash, or I need to replace Evo7 or Evo8 Ecu to this car only?
Thanks for the help.

[todd-w]

7 ecu and use 90550001 ra rom ,you will need to swap a few pins what car ?

[AIK]

you will need to swap a few pins what car ?

Yes, I know it. I Have pin-cards for Evo7 and Evo6. The car is Evo6 (EM2557-00 - RA 420996 EVO 6 Ralliart ECU Group = EVO 5/6 Ralliart Group). Thanks you.

[AIK]

I tried tod with several Evo6 and several 7 Ecu. Always EcuFlesh don't see Ecu. But my openport 1.3 U fave 2 sockets, all cars have 1 (trapezoid) socket only. The problem can in it?

[todd-w]

yes all evos from evo5 up have the second white initialization socket ,, its usually taped to the loom just above the obd socket . il look for a pic for you

[todd-w]

white socket in middle of pic

[AIK]

todd-w
Thanks you.

[todd-w]

let me know how you get on.

[AIK]

OK, If I receive positive results - I'll write how.

[AIK]

1. Connect 62 from the Ecu to 7 to OBD (Having cut off both)
2. Swap pins 8 and 22
3. Swap pins 32 and 34
4. Disconnect pin 87
5. Disconnect pin 20

DON'T
Connect 34 from the ECU to 20 on the vehicle harness
Don't
Connect 32 from the ECU to 21 on the vehicle harness
because we have installed block of management of the engine fan (from Evo7) to 21 pin
6. Switched off immo.

There really two plugs for a cable. Simply the second should look.

[todd-w]

why did you have to do pin62 to obd

[AIK]

why did you have to do pin62 to obd

When i do points 2-6, i has got the engine, but i haven't possibility to read
new Evo7 Ecu in Evo6 (by my Openport 1.3 U cable). When i do 1 point, i have seen and reflash it.