Page 1 of 1
Pajero 4 Rom Read problem
Posted:
Thu Jun 09, 2011 10:21 pmby Editor
So, I have Pajero 4 3.0l and I was trying to read it ROM using Mitsu CAN method and ecuflash and ecuedit soft but all my attempts have finished with no success because some error had occurred during reading procces .
And after it i can't start the engine. Starter is working but engine doesn't start , it'd look like there is no spark events.
Maybe somebody have minds about it?
Re: Pajero 4 Rom Read problem
Posted:
Mon Jun 13, 2011 3:45 pmby radsdau
Sounds like the ECU is not running.
Did you attempt to reflash the ECU? If there was a problem during flashing, this symptom could occur.
If not, make sure the cable is unplugged before starting.
Re: Pajero 4 Rom Read problem
Posted:
Tue Jun 14, 2011 12:06 pmby Editor
It's lool like the flash is gone) far away and the ecu is empty now) and this is a problem. I have already contacted with official mitsu dealer now and we have founded out that there are no any info in ROM now(
Re: Pajero 4 Rom Read problem
Posted:
Wed Jun 22, 2011 10:12 pmby Editor
My car still don't work. But i could reaf my rom using COLT(768) KB method. And as i think flash is correct and problem is in eeprom.
maybe someone can find out what is wrong with this files.
So in attachment are ROm and EEprom.
Re: Pajero 4 Rom Read problem
Posted:
Fri Jun 24, 2011 10:50 amby Editor
Yes, i've been trying to read ROm, only.
So now i have fix this problem. there was 2 incorrect bits in EEprom which transfers ECU in boot mode.
Re: Pajero 4 Rom Read problem
Posted:
Mon Jun 27, 2011 7:21 amby Editor
first file - is a ROM file and have 768 KILObytes size, second one is EEPROM file and have 1024 Bytes size.
Re: Pajero 4 Rom Read problem
Posted:
Mon Jun 27, 2011 5:09 pmby Mitsiman
You have encountered a checksum error in writing back to the ecu. The software is nto configured properly for anything other than the colt vehicles.
Unfortunatly the ecu is now damaged and your only option is to get a repalcement one from Mitsubishi.
We encountered the same problem with two different mitsubishi V6 vehicles, a 2002 challenger and a 2009 Triton which use same method of reading.
Re: Pajero 4 Rom Read problem
Posted:
Tue Jun 28, 2011 2:51 amby Editor
I've understood already that the problem is in checksum
But as i think i can use the eeprom from another ECU with the same part number and copy data from it into my eeprom, and thats the easiest way to fix problem.
So as i;ve said earlier my car is running now but CEL P0603 is lighting up within 5-10 engine starts, and this is single problem I have to solve.
Re: Pajero 4 Rom Read problem
Posted:
Tue Jun 28, 2011 5:04 pmby Mitsiman
You may get lucky but I found trying to flash any stock unmodified rom back onto the ecu resulted in same error. Worth a try though
Re: Pajero 4 Rom Read problem
Posted:
Sun Jul 10, 2011 4:13 pmby Bruce Willis
If a problem yet hasn't solved, it is possible to purchase MMCFLASH to press one button Unlock and a brain will earn.