Mitsubishi Mirage 1998 1.3 petrol automatic
Posted: Tue May 13, 2008 3:50 pmHi to all
Please have a look in the log and tell me why the fuel consumption is so hi...Please. I don't want to go into the full depth of the story but i all ready payed super mechanics to tell me nothing and i decided to buy the evoscan and check things for myself. So i made this log but at the moment don't know what to look at there so i can find a fault. Some people mentioned some pin that lets the petrol that is getting stuck and the car gets too much petrol and just needs a clean but they cannot point the location of it.(probably just stories) I get something like 17l/100km or more and car its like has no power. I checked the TPS and seems fine and working its not a big deal there. I got like 30 ohms just before the switch opens/closes I cant remember. For me that should be ok its like close to 0 unless someone instructs me to change it . (Im a electronics engineer ).I checked voltages for MAF and TPS before ECU and they are in the accepted values(according to AUTODATA 3.18).Beside that i get an old error code (im just guessing its old) that speed sensor is defective and i remember that i changed a 10 amps fuse that was going to it. I hope i gave as much info as possible. There might be some more but cant think of it.
Regards Sylma
Please have a look in the log and tell me why the fuel consumption is so hi...Please. I don't want to go into the full depth of the story but i all ready payed super mechanics to tell me nothing and i decided to buy the evoscan and check things for myself. So i made this log but at the moment don't know what to look at there so i can find a fault. Some people mentioned some pin that lets the petrol that is getting stuck and the car gets too much petrol and just needs a clean but they cannot point the location of it.(probably just stories) I get something like 17l/100km or more and car its like has no power. I checked the TPS and seems fine and working its not a big deal there. I got like 30 ohms just before the switch opens/closes I cant remember. For me that should be ok its like close to 0 unless someone instructs me to change it . (Im a electronics engineer ).I checked voltages for MAF and TPS before ECU and they are in the accepted values(according to AUTODATA 3.18).Beside that i get an old error code (im just guessing its old) that speed sensor is defective and i remember that i changed a 10 amps fuse that was going to it. I hope i gave as much info as possible. There might be some more but cant think of it.
Regards Sylma