openecu.org

The problem with me is, ECU won't read the callibration file. Please suggest how to cope with the problem. Thanks everybody in advance. Here are the detailed data:
2008 EDM Subaru Impreza WRX 2.5L Turbo MT ECU ID 5142584007 Sistem ID A2101101

Please post the stock ROM.

Please tell me where this informations can be found

Ok: Use your OpenPort2 cable and ECUFlash to read the ROM from your car. If the ROM code is not recognized, choose the ECUFlash option that still allows you to save the ROM file. That's the file to post here.
MY08 should be CAN and probably doesn't require the green test mode connectors to be linked, but it doesn't hurt, especially if you're having trouble.

Thank you very much for your advice! A little later, try and write what happened

Hooray! Success! I understood everything. Thank you very much. I enclose a ROM.
By the way green test mode connectors do not connect, and so everything works.

Good to hear, well done.
AZ1E400U: based on AZ1E400C. ROMRaider supports this ROM.

OK. Thank you! I'll try and write about the result.

I tried it and here's the result:
ECUflash and ROMRaider supports this ROM, but the Learning View is not connected to the ECU.
Interestingly, the ECUflash started working only when I installed it on another laptop.

Learning View has its own set of defs (internally defined) afaik, so it's likely just not supported.
I don't know why installation on another laptop fixed it. I presume something went wrong with the Metadata directory settings.