LC-1 not reading properly
Posted: Sat Nov 29, 2008 8:29 pmmy LC-1 is logging AFR at 4.2 at idle, i've recalibrated and it does the same thing. Am i making some noob mistake?
ardevas09 wrote:my LC-1 is logging AFR at 4.2 at idle, i've recalibrated and it does the same thing. Am i making some noob mistake?
Is this in LogWorks, the RomRaider logger, or?
Only thing I can think of is run the LM Programmer software to be sure it's set for gasoline.
Beyond that if you do heater and free air calibrations and it's still off it's got to be either the sensor or the controller.