Page 1 of 1
jdm bh5 2002 legacy gtb twin turbo tiptronic
Posted:
Fri Dec 28, 2007 6:37 pmby E-TUNE GTB
Hello guys, im trying to edit my ecu as it has far to much timing. I have ECUFLASH and ENGINUITY, tactrix 1.3 cable etc. Does anyone have the definitions for this ecu :
1y
22611ag451
112200-0995
12v
denso
as i can read the rom but cannot open the hex file in any programme, am i doing something wrong?
heres a file i read of my ecu
Posted:
Fri Dec 28, 2007 7:48 pmby west_minist
Add this file to the ECU Definition Manager.
Posted:
Fri Dec 28, 2007 8:41 pmby E-TUNE GTB
how do i do that? and what programm is that file for? enginuity or ecuflash?
Posted:
Fri Dec 28, 2007 8:47 pmby E-TUNE GTB
ok added it in enginuity.. dont think its quite the correct definition as it said somethings were out of bounds.. but has loaded the bulk of the file
cheers
Posted:
Fri Dec 28, 2007 8:50 pmby west_minist
Thats ok. All values appear correct in the required maps.
Posted:
Fri Dec 28, 2007 9:33 pmby E-TUNE GTB
if i wanted to pull some timing in the midrange to stop detonation, what tables would i modify? main ignition IAS open or IAS closed, i have limited knowledge on this.. cheers
Posted:
Sat Dec 29, 2007 12:08 amby west_minist
It depends if you are open or close of the IACV.
Normally for a quick fix, you can reduce the ign adv by half.
Posted:
Sat Dec 29, 2007 12:20 amby west_minist
Posted:
Sun Dec 30, 2007 12:06 pmby E-TUNE GTB
so i open that file in ecuflash and flash it to my ecu?
Posted:
Fri Feb 08, 2008 8:01 pmby Kosti
For out of bound msgs try converting to 192K