openecu.org

Hy.
I'm french and will try to discuss in simple good English.

I was using Ecuflash 1.39 for a long time without problems.
I downloaded Ecuflash 1.4.

Now i can't modiy any value as : disable to enable.
Each time i try o change a value from disable to enable or enab to disab, Ecuflash writes "no match" and no way to go back ...

I tried on 2 laptops, and that's the same. Tried to download once again, that's the same ...

Am i stupid or is there a bug ?

With 2D or 3D maps, no problems with values ....

That is an issue that will be fixed in the next Ecuflash update. Until then, you can use RomRaider with any of the switch tables - DTCs, etc.

Thank's.
I'm not so stupid so !
LoL.