openecu.org

Hi

I have problem to open the Hex file for JDM EVO 8 MR.
The hex file already downloaded succesfully with Ecuflash v1.32 but the file couldn't be open. Needs definition file for MN 191140, E6T 34886 H.

I also attach the Hex file.

Please help me with this problem.

Thank you for your attention & help

Regards
Setiawan

Anybody please help me. Thanks

Here you go

cossie1 wrote:Here you go

Cossie1, Thank u, thank u, and thank u! .. I'll try it.

One more thing, where/how should I install it to make it work?

Once again Thank you

If you have a look at your openecu\ecuflash folder, there is a rommetadata folder in there. Put the definition in there, under the Evo subfolder.

salex wrote:If you have a look at your openecu\ecuflash folder, there is a rommetadata folder in there. Put the definition in there, under the Evo subfolder.

got it ... thanks Salex!!

Off topic does anyone have the installer for 1.32?

cossie1 wrote:Here you go

Hi Cossie

I have tried using your XML but the table open with many funky numbers.
Did I do something wrong?

Thanks

Works fine for me, with ecuflash 1.33.

Try deleting the definition from your romdata folder.

Then start ecuflash

Then close it and add in the xml added above again.

Then restart ecuflash.

cossie1 wrote:Works fine for me, with ecuflash 1.33.

Try deleting the definition from your romdata folder.

Then start ecuflash

Then close it and add in the xml added above again.

Then restart ecuflash.

Hi Cossie1

Yessss .... Finally it's work after I upgrade to v1.33 (use to be v1.30).
Now the tables open nicely.

Many thanks to your help!!!

Glad you got it sorted mate