openecu.org

Hi All

Need help badly. I have already managed to connect, download. I have even managed to flash mhy stock file back via ecuflash. But now i have another problem.

When i use enginuity to edit, and try to flash using ecuflash, it always fails!!! What could be the problem. It seems that the error is only after i edit and save in enginuity. Are there any steps/conversion that i have ommitted?

Also, please look at the file, there is something different for ECUFlash and Eginuity. Look at the address for Fuel Cut....(Same File) but address is different

Please help

which version of both software, are you using

is it 'coz ecuflash is a 192kb file & Eginuity is a 160kb file?

This issue was solved on the Enginuity site. It is because Ecuflash didn't support his rom, so he inherited another rom from the same model whose table defs were not a match for his own. The flashing issue was unrelated.