Page 1 of 1
Where do I find the case ID and Internal ID on my EVO ECU?
Posted:
Sun Jun 18, 2006 2:09 pmby allcdsrus
Im lead to believe its under the dash, but can anyone indicate where exaclty. I see the Plugs I connect to but there is no labelling there but there is another large white section at the opposite side.
Thanks in advance
AC
Posted:
Mon Jun 19, 2006 10:18 amby SilverBack
If you mean, where is the engine ECU...?
Behind the glovebox on the 9.
Open glovebox.
Find peg thingy, top right hand corner, slide and remove.
Push the left hand side in, to push passed that stop peg and drop the glovebox down to access behind to locate ECU
Posted:
Mon Jun 19, 2006 11:18 amby allcdsrus
Thanks for the response
I believe my code is MR 975815
Does anyone have any def's for this?
Many thanks
AC
Posted:
Fri Jun 23, 2006 11:47 pmby burgers
Hi
If you read the map and upload it to the Mistubishi ROM files part of this web site, I'm sure someone will have a look at it for you. What model and market is the car?
MB
Posted:
Sat Jun 24, 2006 3:04 amby YP
allcdsrus wrote:Thanks for the response
I believe my code is MR 975815
Does anyone have any def's for this?
Many thanks
AC
Attention! MR975815 is a
PASSANGER AIR BAG MODULE for CS2-CS5 Lancer JDM. Don't touch it.
Posted:
Sat Jun 24, 2006 4:55 amby allcdsrus
thanks for the reply, I was informed to look behind the glove box to find the case id for my ecu...that MR code is the only one I could see.
Doh...thats why the code made no sense
Posted:
Sat Jun 24, 2006 7:38 amby burgers
Hi
You have to take the ECU out to see the case number. If you can see all the wires going into the ECU you should be able to see where the ECU is held in, on my car there are 3 M6 bolts.
You realy need to take the glove box out, the stopper nearest to the centre of the car pops outand then you can get the golve box out.
MB
Took out my ECU...
Posted:
Sun Jun 25, 2006 2:05 pmby allcdsrus
And on the case it had the following
MN132750
E6T34877 H 3304