openecu.org

Posted: **Sat May 27, 2006 3:40 pm**

Hey all just wanted to introduce myself Im new to the site, Ive been reading the posts and scoobpedia and the engenuity site for about two weeks now and just wanted to know if any of you have tried modifying a 2006 WRX using ECUEDIT yet? I know engenuity doesnt support drive by wire cars yet but from waht I have read ecuedit does. How have you who have experience wit th drive by wire cars done?

Posted: **Sat May 27, 2006 6:29 pm**

Also Im still awaiting my cable which should be herein a few days, I plan on ripping my rom from my ecu, where exactly do I upload the rom to on this site? Ive noticed theres not a single 2006 WRX rom any where lol, figured Ide be the first.

Posted: **Sun May 28, 2006 8:57 am**

I would love to see one myself.

Posted: **Sun May 28, 2006 9:16 am**

I would only use EcuFlash for this at this point. As far as I know, it's the only program that corrects the checksums on the fly.

Colby

Posted: **Sun May 28, 2006 9:28 am**

I will have a 06 rom posted tonight.

Jason

Posted: **Thu Jun 01, 2006 8:33 pm**

K got my cord I can datalog perfectly but Ecuflash for some reason isnt working, any suggestions? Just says its not hooked up. No ecu connected.

Posted: **Wed Jun 14, 2006 12:18 pm**

I'm not an expert, but you may have to connect the green test connectors above the pedals to make it work. I know that's the only way to flash with the cobb ap.

Posted: **Sun Jun 18, 2006 7:57 pm**

I successfully read my rom off an '06 wrx
the green test connector on the passenger side was disconnected
it took me a while to find, it was not under the kick panel,
but actually inside the plastic lining at th base of the A-collumn.
Everything was smooth once i got that plugged in.

Any interest in posting rom images? (A8DH200X)

Posted: **Mon Jun 19, 2006 1:51 am**

I wired my green test connectors up to a switch in the console near the handbrake. I just got some 2 core cable, a male and female spade connector and a on/off switch with a cover so when the cover is closed the switch is off. Took me about 20 minutes to do. Now I can drive my car, log, check logs, adjust map and flash and I don't have to get out of the driving seat.

Posted: **Wed Aug 09, 2006 8:12 am**

err0rr wrote:I successfully read my rom off an '06 wrx
the green test connector on the passenger side was disconnected
it took me a while to find, it was not under the kick panel,
but actually inside the plastic lining at th base of the A-collumn.
Everything was smooth once i got that plugged in.

Any interest in posting rom images? (A8DH200X)

I'd like to see it.