2007 subaru jdm sti new shap
Posted: Fri Jan 30, 2009 7:34 amhi i have a 2007 subaru new shap
want to read the ecu
can any help
want to read the ecu
can any help
openecu.org
Forums for ECU reverse engineering and modification
http://forums.openecu.org/
2007 subaru jdm sti new shap
Page 1 of 1
Posted: Fri Jan 30, 2009 7:34 amRe: 2007 subaru jdm sti new shap
Posted: Sun Feb 01, 2009 5:38 pmUse OpenPort2 cable with Subaru CAN hookup method.
Re: 2007 subaru jdm sti new shap
Posted: Tue Feb 17, 2009 2:02 amhi there thanks for your reply but i did try the CAN but did not work , is the a way to do this ?
thank you
thank you
Re: 2007 subaru jdm sti new shap
Posted: Tue Feb 17, 2009 2:57 pmIt is possible the 05DBW method is used for these, but I would have thought CAN was more likely. Give the other Subaru hookup methods a go.
If it's not CAN, you will need to connect the green test mode connectors. There may be more than one set; make sure the fans cycle when the ignition is turned on after connected the test mode connectors.
If that doesn't work, sight the ECU and perhaps even post a photo of outside and inside.
If it's not CAN, you will need to connect the green test mode connectors. There may be more than one set; make sure the fans cycle when the ignition is turned on after connected the test mode connectors.
If that doesn't work, sight the ECU and perhaps even post a photo of outside and inside.
Re: 2007 subaru jdm sti new shap
Posted: Sat Feb 21, 2009 10:28 ami have done many 2004-5 but this is the new shap and cannot find the green / black plug ?
Re: 2007 subaru jdm sti new shap
Posted: Sun Feb 22, 2009 3:18 pmOdd. If it's the new shape it should be CAN. The CAN ones I've seen haven't required the green connectors to be connected.
Re: 2007 subaru jdm sti new shap
Posted: Mon Mar 02, 2009 4:01 amdo you think i have the right lead ?
as when i tryed it on can it closed the program down ?
as when i tryed it on can it closed the program down ?