I have downloaded and installed ECUFlash and I am unable to write to my car's ECU. I can read the programm off the ECU with no problem. The ECU goes into utility mode when I attempt to write to the ECU but I get a message saying programming voltage is too low.
Any ideas?
Problem Flashing '04 WRX - ECU Model #AJ800-8920
Moderator: Freon
1 post
• Page 1 of 1
Problem Flashing '04 WRX - ECU Model #AJ800-8920
by Stig » Tue Jul 15, 2008 1:33 pm
- Stig
- Posts: 4
- Joined: Sat Jul 12, 2008 6:49 pm
1 post
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest