openecu.org

which cable to get on the limitless site. does it matter which one. specifically which one. i got a mirage w/evo 4 swap planning to go with an evo 8 ecu....? which one is best to suite to reflash evo 7-8 ecu on the evo 4.

EvoScan HighSpeed Mitsubishi/Subaru USB Datalogging Cable
(also known as OpenPort 1.3U Cable)
Datalogging and ECUFlash Reprogramming Cable.
High quality and high performance 12pin + 16pin datalogger/reflash cable, capable of extreme high speeds.
Perfect for EvoScan, StiScan, EcuFlash, OBDII software.
Specifically supports 1994-2005 Mitsubishi vehicles for EFI, AYC and ABS systems. Bonus! allows reprogramming of Subaru WRX/Sti ECUs and Mitsubishi Evo factory ecus via EcuFlash (included reflash connector) Also Supports 1999-2006 Subaru SSM-II vehicles for datalogging.
____________________________________________

EvoScan 2006+ Mitsubishi/Subaru ELM327 CAN Protocol USB Cable
High quality and high performance datalogger cable, capable of extreme high speeds.
Perfect for EvoScan, and supports all U.S. OBDII vehicles since 1996-2007, and all elm327 software. Includes support for CANBUS vehicles
For vehicles such as DSM/Subaru/Mitsubishi/3000GT I would highly recommend using the specialised Datalogger/Reflashing cable below.

OpenPort 1.3U Cable and ecuflash , im using a evo7 ecu in my evo4 for a while now ,with a few wiring changes fuel pump /rad and a/c fans ,then run a wire to ecu pin 79 for the white socket and wire in a heated o2 sensor as its not on the e4, think its on the mirage though.

best bet is get pinout diag for both ecu and see what pins are different, i have the pinouts for 96 for lancer mivec which i would assume is very similar to mirage. i can pm it to you if you need it .

Which cable works with EvoScan v2.2 and 2004 WRX?

I have a tactrix cable OpenPort 1.3 but it's not the universal one. They don't even sell mine on tactrix.com anymore. Their website is horrible. The one I have is called "OpenPort for Subaru WRX and Drive-by-wire vehicles". I am guessing it should work the same as the 1.3U but I cannot get EvoScan to initialize.

Anyone out there using EvoScan with their WRX? Help please!