openecu.org

Hi,

I met Outlander 2.0T with that white connector.
Two pins are metallized only!!!
I had no chance to see ECU and have no info about processor now.
Is there solution for reflashing that car?
May be can somebody help with info about processor.
I've seen http://forums.openecu.org/viewtopic.php?t=759&start=0
may be (or may be not) about this subject and I want to know:
1.) Is this MH8202F?
2.) Is there the tool for fleshing this proc.
3.) With what processor MH8202F is compatible (MH8206, MH8305F, 7202)?

Thanx in advance.
_______________________
m.o.r.f.e.u.s_@hotmail.com

brother im not sure bout outlander
but im using ecuflash for my airtrek turbo which has the similar port as the 1 u posted
the cable we get is for evo so need to customise a bit to fit the port..
juz my 2 cents...

Thenx,
But do you know something about this port customising?
I would be very thenkful for any info.

national12345 wrote:brother im not sure bout outlander
but im using ecuflash for my airtrek turbo which has the similar port as the 1 u posted
the cable we get is for evo so need to customise a bit to fit the port..
juz my 2 cents...

Hey bro...

- Locate the thinner cable that also connect to the OBD connector
- Push out the (thin cable) PIN using a small screw driver/clipper
- Use a plyer to squeeze the PIN into a needle like shape

- Bend down (use a torch light) and locate the green colour cable that connect to your car white connector. Airtrek green cable is located at the top left side second pin
- Gently push the reshape pin into the hole (where the green is connector)
- Connect the OBD connector
- Fire up ECU Flash
- Use e7/8 or e9 to read the ecu

Note - Keep the tatrix connector in case u want to use for EVOs

1000 thenx!!!
I'll try that !!!

Here some details you ask.

MCU is MH8202


Some pictures of the ecu too.


Bye


Christian Piasini
R&D Piasiniengineering