openecu.org

log reads like this every time I try to read my ecu, this is an 06 WRX, green flash cables are connected under steering column:

[00:25:01.656] Version 1.29.906
[00:25:01.656] 8 memory models read.
[00:25:03.000] 141 ROM metadata models read.
[00:25:03.000] checksum module "subarudbw" loaded.
[00:25:03.000] flashing tool "wrx02" loaded.
[00:25:03.000] flashing tool "wrx04" loaded.
[00:25:03.000] flashing tool "sti04" loaded.
[00:25:03.000] flashing tool "sti05" loaded.
[00:25:03.000] flashing tool "mitsukernel" loaded.
[00:25:03.000] flashing tool "mitsukernelocp" loaded.
[00:25:03.000] flashing tool "mitsubootloader" loaded.
[00:28:02.046] ssm2_init
[00:28:02.203] ECU ID is 43 12 58 41 06
[00:28:02.203] ssm2_cmd_0x81
[00:28:02.250] ssm2_cmd_0x83
[00:28:02.296] denso challenge-response
[00:28:02.343] challenge is 54 AE 8C 21
[00:28:02.343] response is 00 42 B3 32
[00:28:02.390] ssm2_cmd_0x10
[00:28:02.750] validating denso kernel ram area addr: FFFF3000 len: 0C28


Tried reinstalling about 5 times now, any help would be much appreciated.

Thanks

What cable are you using? When you unistalled Ecuflash did you also uninstall all the drivers (FTDI/Openport) that were in add/remove programs?

Yah uninstalled the 2 openport programs in add/remove, and fidi wont remove no matter how many times I try to uninstall it, and the cable is Tactrix OpenPort logging & reflash cable for Subaru Drive-by-wire vehicles, says openport 1.2 on the ebay auction I bought it off of, but the drivers installed with ecuflash were version 1.3

are the green connectors that need to be connected together under the steering column or by the ecu itself(passenger side)?

nm got it

-pls say how you fix?