I had an MRT XB kit installed last week and have been experiencing knock issues... I assume the logs arent good, however i am not that proficient in reading them
The test was to see how the knock correction reported under load. I drove to 60km/hr, stuck it in 5th and floored it.
I use BP ultimate (98ron) and the car feels like ass when accelerating. I have previously reset the ECU and it feels smooth for a while and the knock correction remains quiet high, then it tends to revert back to the minus figures under slight load then all over the shop when accelerating.
Can anyone please shed some light?
some pics:
http://members.iinet.net.au/~phat/run1.jpg
http://members.iinet.net.au/~phat/run2.jpg
some ecuexplorer graphs:
http://members.iinet.net.au/~phat/ecuExplorer [AL390-2230] - Run 1.csv
http://members.iinet.net.au/~phat/ecuExplorer [AL390-2230] - Run 2.csv
also what is the IAM address for the AUS 06 STI?
Thanks