4.32v programming voltage is too low
what am I doing wrong? Any ideas? I'm flashing the 192Kb file (which should work).
this is an 02 wrx A4SGC00C ecu and I have a UTEC in there too...wonder if that is leeching some voltage?
I've connected the green test connectors and jumpered the 2 connectors in the white block with wire.
190.253] Flashing image to ECU memory...
[0.000] kernel flash disable
[3.095] denso02_bootloader_cmd_start
[0.030] 1452 byte kernel read.
[0.000] kernel checksum is valid (n = 2).
[0.200] writing denso kernel area addr: 020000 len: 05AC
[2.854] kernel get version
[0.030] kernel version is : OpenECU Kernel V0.91
[0.401] comparing ECU flash memory pages to image file
[0.000] comparing ECU flash memory pages to image file
[0.000] page ecu CRC32 img CRC32 same?
[0.340] 00 9E7D9C31 9E7D9C31 YES
[0.351] 01 8F606882 8F606882 YES
[0.330] 02 0216DE1B 0216DE1B YES
[0.341] 03 D3FE83A7 D3FE83A7 YES
[0.330] 04 3ED4232E 3ED4232E YES
[0.321] 05 9B898AB6 9B898AB6 YES
[0.320] 06 939D0A27 939D0A27 YES
[0.351] 07 4BE24516 4BE24516 YES
[0.340] 10 CC471A1C 57C1C10E NO
[0.331] 11 20A51562 C6D6FF9A NO
[0.010] reading ecu programming voltage
[0.030] programming voltage is 4.32 volts
[0.000] programming voltage is too low!