Freon wrote:
(dancing banana goes here)
HAHA thats funny!!!
Moderator: Freon
JRSCCivic98 wrote:Can I send you my OpenPort 1.0 and get it upgraded?
jamesohoh7 wrote:dumb question perhaps, but can this new release be used with a Cobb AP interface cable to just read my car's ROM (USDM '05 STi)? In light of the OpenPort 1.2 cable requirement, I'm wondering about the Cobb one?
I'm not interested in reflashing my ECU just yet, I just want to get a ROM dump right now. If I can do that reliably w/an AP cable, I will do so.
I am searching for a FAQ that addresses this, sorry if this has been answered... but I got so hyped when I saw this announcement, I had to ask immediately if not sooner
Thanks!, killer work, kudos to all!
-James
cboles wrote:common, but not a dumb question
the Cobb cable will not work because the baud rate cannot be controlled properly (a serial port issue, not a cable issue), and because the STi version of the software uses a high baud rate which is probably too fast for that cable.
Colbyjamesohoh7 wrote:dumb question perhaps, but can this new release be used with a Cobb AP interface cable to just read my car's ROM (USDM '05 STi)? In light of the OpenPort 1.2 cable requirement, I'm wondering about the Cobb one?
I'm not interested in reflashing my ECU just yet, I just want to get a ROM dump right now. If I can do that reliably w/an AP cable, I will do so.
I am searching for a FAQ that addresses this, sorry if this has been answered... but I got so hyped when I saw this announcement, I had to ask immediately if not sooner
Thanks!, killer work, kudos to all!
-James
Jaxx wrote:well it seemed to work
produced a 1024k file
but identified my lgt as an auto not a manual
KGreb wrote:Not getting a ROM dump here, just an error message. OpenPort 1.2, '05 LGT.
10 lines of "ssm2_init" then "kernel get version" then "validating denso kernel ram area addr: FFFF0000 len: 0008" followed by a pop up error.
Any ideas?
EDIT- Just tried on our '04 FXT and it worked, so hardware/software setup seems to be ok. Must be something with this particular ECU.
Users browsing this forum: No registered users and 0 guests