Hi. I would like to connect a Subaru STI ECU out of the car. I have hooked up using this pattern:
E2, E3, E10, A14 to 12v
E15, B17 to gnd.
A5 to gnd is the green test connector
A20 to OBD pen 9 is the L-Line
A21 to OBD pen 7 is the K-line
A10 to OBD pen 11 is the flash voltage.
Connector A=B134, B=B136, E=B137
And this is what I obtain in ecuflash:
[18:02:43.149] Device Firmware Version: 1.07.2597
[18:02:44.287] kernel get version
[18:02:44.646] SSM2 init
[18:02:44.808] SSM2 ECU ID is 2E 44 59 61 05
Anyone can help me to get this ecu work out of the car?
I have some dubts on A20 and A8 connections, which are che pin that I have to bridge on the car.
Thanks to all.