I was able to read the stock map off of my ecu, but when i tryed to load up the new map i got the low voltage message and could not load the map. I then appiled 12v to the flash block, and tried again loading the map and reading the ecu but i go the denso02 boot load message and unable to load kernel, kernel flash disabled.
Is it possible that i f**k up the ecu and locked so i cant acces the ecu and write or read any maps.?
This is the only result i get after jumping the 12v wire.
1452 byte kernel read.
kernel checksum is valid (n = 2).
kernel image loaded and verified.
196608 byte image read.
ecu image loaded.
denso02_bootloader_cmd_start
denso02_bootloader_cmd_start
denso02_bootloader_cmd_start
denso02_bootloader_cmd_start
denso02_bootloader_cmd_start
kernel flash disable
rkrv: preamble 1 no response
unable to load kernel
<< PROCESS COMPLETE >>
I also have a portmon log of when i tryd accessing the ecu.
i couldnt and the attachment with the log so if any could help me out i could email them the log. idk it might have attached i tried to.
PLEASE HELP Me
Thnk you
Jordan