I'm looking to find the 2 and 4 pin connectors used on the 02-05 MY WRXs for initialization to reflash. Like the ones pictured on page 5 of this
http://www.accessecu.com/support/ap-usersguide-wrx.pdf
Anyone know where to buy these?
Moderator: Freon
qoncept wrote:Colby, do you know where we can get these? I think I'm about to just say screw it and buy a different male and female connector and solder it on.. Or, better yet, just complete the circuit with a switch.
ahains wrote:
Many of us just use a simple piece of wire to jumper it, like pictured here:
http://www.dvihdmicables.com/WRX/ECUF-How-To.htm
There is no harm in leaving it connected full time. This is what I and most folks do.
You only connect the green connectors when you are flashing, but the flash block can stay connected.
Users browsing this forum: No registered users and 0 guests