Whats going on here?
Posted: Tue Apr 04, 2006 12:25 am
Hi iv obtained my fuel map on my Ecutek 3. Car is a 03 STi running Fp green, standard pinks/ walbro pump etc
why do I have two 0.02 engine load columns running the same target AFR's ???? Also, Shouldnt it be targetting stoich = 14.7 ?
Iv done some data logging and im getting negative knock correction at low revs, and then positive all the way up. My advance multiplier stays at 16 the whole way
why do I have two 0.02 engine load columns running the same target AFR's ???? Also, Shouldnt it be targetting stoich = 14.7 ?
Iv done some data logging and im getting negative knock correction at low revs, and then positive all the way up. My advance multiplier stays at 16 the whole way