Hi,
I work whit renesas device in industrial. I have a lancere evo 9 and i try to read my MCU, but i cant because a K-line i whiring in the SCI0 not in SCI1 and I can't use the strandard boot loader sequence.
I have found information for use a mitsubishi kernel. I have see when i set the 16 V on pin, elettronic set the MOD pin to boot loader and perform one reset pulse.
I have try to make the boot loader, and I have load whit mitsu protocol, but my monitor never run, and after load my monitor, i can read and write whit standard mitsu command. I don't understand why !?!?!??!
Can i write my kernel and load to run in ram ?
Tanks.