Info kernel

Developer topics relating to software that provides a tuning UI to alter ECU code and data

Moderator: Freon

Info kernel

Postby invisigothux » Mon Jun 04, 2007 2:00 am

Hi,

I work whit renesas device in industrial. I have a lancere evo 9 and i try to read my MCU, but i cant because a K-line i whiring in the SCI0 not in SCI1 and I can't use the strandard boot loader sequence.

I have found information for use a mitsubishi kernel. I have see when i set the 16 V on pin, elettronic set the MOD pin to boot loader and perform one reset pulse.

I have try to make the boot loader, and I have load whit mitsu protocol, but my monitor never run, and after load my monitor, i can read and write whit standard mitsu command. I don't understand why !?!?!??!

Can i write my kernel and load to run in ram ?


Tanks.
invisigothux
 
Posts: 1
Joined: Thu May 31, 2007 12:53 am
Location: Italy

Return to Tuning Software

Who is online

Users browsing this forum: No registered users and 5 guests