Page 1 of 1

Can`t read EVO5

PostPosted: Tue Jun 25, 2013 11:17 pm
by Falcon
Hi, all! Trying to read Evo5:

[20:26:19.843] using metadata XML ID read_evo5 from file C:/Program Files/OpenECU/EcuFlash/rommetadata/read templates/read_evo5.xml
[20:26:19.890] J2534 API Version: 04.04
[20:26:19.890] J2534 DLL Version: 1.00.3719 Dec 28 2012 23:38:48
[20:26:19.890] Device Firmware Version: 1.12.3688
[20:26:19.890] Device Serial Number: TAHhQTbe
[20:26:22.171] sending init sequence 2
[20:26:22.171] got 0x10 response instead of 0x11
[20:26:22.171] sending init sequence 3
[20:26:22.515] entering bootloader
[20:26:22.515] sending kernel size (2029)
[20:26:22.515] error sending kernel size
[20:26:22.515] interface close

They are reflashable as i know... or i mistake?

Re: Can`t read EVO5

PostPosted: Thu Jun 27, 2013 11:24 am
by ayashiko
boot PIN, please make sure the voltage should be 16 - 18 volts

Re: Can`t read EVO5

PostPosted: Fri Jun 28, 2013 1:30 am
by todd-w
openport 2 ???

Re: Can`t read EVO5

PostPosted: Wed Jul 10, 2013 3:05 am
by Falcon
Sorry, for long response...
Yes i use OP 2.0.
Boot Pin must have 16-18V always?

Re: Can`t read EVO5

PostPosted: Wed Jul 10, 2013 10:17 am
by Sasha_A80
got 0x10 response instead of 0x11 - it's not H8/500 device

try mitsukernelocp

Re: Can`t read EVO5

PostPosted: Sun Jul 21, 2013 3:55 am
by Falcon
Didn't understand anything...

Re: Can`t read EVO5

PostPosted: Thu Jul 25, 2013 2:13 pm
by todd-w
is it possible the ecu was changed for evo7/8 type ecu

Re: Can`t read EVO5

PostPosted: Fri Jul 26, 2013 4:07 am
by Falcon
No. There was the Evo4 Ecu before. Then it was replaced by Evo5 ecu

Re: Can`t read EVO5

PostPosted: Sun Aug 04, 2013 4:53 am
by todd-w
try reading as evo6 tme 7203 or have a look see what the ecu board number is