openecu.org

Posted: **Fri Aug 19, 2005 6:20 pm**

Colby / others:

can you describe the method you used in figuring out how to design the kernels and utilities you have to dump memory / etc?

I am trying to do the same for the JECS Subaru ecu which is a MITSU M32R or specifically (M32150F4TFP) as far as I know.

Can you elaborate on the steps ou tool in development and what information you needed to write the kernel? does the kernel that you use to dump the memory require significant programming that will be overly processor specific?

What aspects of the processor datasheets did you use in you development?

Todd

Posted: **Sun Aug 28, 2005 9:15 am**

Any luck downloading the rom for this manufacture?

Posted: **Mon Aug 29, 2005 6:01 am**

Yes this would be great, this will open up the doors for MY99/00 cars aswell, like my STi VI

Posted: **Fri Dec 23, 2005 2:01 am**

i was wondering this myself... its not like there is any available documentation for this, how did you go about finding out where to start, etc... just thought i'd try to revive this thead...

Posted: **Fri Dec 23, 2005 3:18 am**

Please check http://forums.openecu.org/viewtopic.php?t=192&start=15 here for all JECS ROM info.

Posted: **Mon Jan 02, 2012 5:42 am**

here you are

openecu.org

Designing ecu utilities for reflashing and dumping

Designing ecu utilities for reflashing and dumping

Re: Designing ecu utilities for reflashing and dumping