Page 1 of 1

Trying to get OpenECU HW working with Tari software

PostPosted: Thu Jun 02, 2005 9:15 am
by twg
I just got my OpenECU HW...

I installed the FTDI 232BM drivers.. the VCP drivers...

I then installed the Tari DL1...

I am using COM5..

When I start Tari, it says that it cannot communicate with the ECU...

I tried the free version of VE1, but it only supports up to COM3, so no go..

Any suggestions ?

PostPosted: Thu Jun 02, 2005 5:10 pm
by west_minist
Change the driver com port in computer management console.

PostPosted: Thu Jun 02, 2005 6:47 pm
by twg
not sure why it didn't work on COM5, but once I freed up COM3, it worked..

free version of VE1 didn't work still though...

PostPosted: Thu Jun 02, 2005 6:50 pm
by west_minist
once the program call for a port, it will not work on another.

freeing up the com3 with work as you stated.

PostPosted: Thu Jun 02, 2005 10:42 pm
by calvinc
twg...

did you manage to get the software working yet? if not send me an email.

calvin.
www.tari.co.za

PostPosted: Fri Jun 03, 2005 2:26 am
by west_minist
But then again, the Tari gives you com1 to com9.

So just select the port in the future and you are good to go. :)

PostPosted: Fri Jun 03, 2005 12:49 pm
by higB_0x05
I cant get your software to work with this board:
http://www.andywhittaker.com/ecu/obdii_hardware.htm

:( should it?

PostPosted: Fri Jun 10, 2005 11:13 am
by west_minist
I am now in the same boat. i cannot even get the driver install.

Anyone know which file I need to download from FTDI?

PostPosted: Fri Jun 10, 2005 6:15 pm
by cboles
you need the driver for the FT232BM

PostPosted: Fri Jun 10, 2005 6:19 pm
by west_minist
I realise that when the first drivers failed.

It took awhile to get them install, but there are working great.

My only problem right now is logging. The Tari software are not showing the right results and the sample code on the net does not have the AFR reading.

Thanks cboles

PostPosted: Sat Jun 11, 2005 10:55 am
by realwomble
Look at the other free logger in the dataloggin development section - that will read AFR, and there is source code.

PostPosted: Sat Jun 11, 2005 11:36 am
by west_minist
It wouldn't work.

Mike own is the only one that read afr.

PostPosted: Thu Jun 01, 2006 1:11 am
by Evo4Mad
I have tried installing a number of drivers with OpenPort 1.3M, but cant get the Virtual ComPort to appear anywhere. not in the device manager.

PostPosted: Wed Sep 27, 2006 8:22 am
by grippgoat
Evo4Mad wrote:I have tried installing a number of drivers with OpenPort 1.3M, but cant get the Virtual ComPort to appear anywhere. not in the device manager.


I think I'm having the same problem with my OpenPort 1.3 for Subaru DBW.

-Mike

PostPosted: Fri Sep 29, 2006 8:04 am
by johsti
I'm having a poblem with a nonDBW subaru.