Page 1 of 1

Does anyone know where I can find this EVO connector?

PostPosted: Wed Nov 02, 2005 11:04 am
by cboles
I'm trying to find a source for this EVO connector which is used to put the ECU in a special mode where it can be reflashed. I don't see any distingushing text / symbols on the connector which would reveal the manufacturer. Does anyone know who makes this or where I can get some?

Colby

PostPosted: Thu Nov 03, 2005 7:54 am
by cdvma
Looks like a Molex, but then again a lot of things do. I'd get a catalog (or online) from Mouser or Digikey they have pages of pictures of connectors.

PostPosted: Fri Nov 04, 2005 7:28 am
by calvinc
looks very similar to this one off the old legacy. missing 2 pins though, but might be same manufacturer?

http://www.graphics.cornell.edu/~v/bcbfscan/

calvin.

PostPosted: Tue Jan 03, 2006 4:03 pm
by cboles
Found it! It is a Sumitomo F(6244-5121) 12-way connector listed on page 3 of the attached PDF. Socket pins for it are on page 2. Special thanks to Thomas Dorris of ecmtuning.com for letting me know that it was a Sumitomo part.

Colby

PostPosted: Mon May 15, 2006 12:30 pm
by GTODesign
Does this connector tie to pin 79 on the ECU side?

PostPosted: Tue May 16, 2006 4:10 am
by GTODesign
Just tried it and it's definately tied to pin 79 on an E7 ECU.

PostPosted: Thu Jan 18, 2007 7:22 pm
by Evo4Mad
what website or ph number can you get these plugs from?
Sumitomo F(6244-5121) 12-way connector

PostPosted: Fri Jan 19, 2007 12:21 pm
by todd-w
like to know that too, please.