Re: Openport Stand-Alone Logging Beta
Posted: Wed Jun 09, 2010 7:55 am
Does anyone know if you can / how to set multiple conditions? I'd like this to say log only with cruise switch and engine on, but stop if cruise off or RPM less than 2500 (2008 evo x):
I'm not sure if it should be this based on the way the other operators are set up:
- Code: Select all
Code:
conditionrpn = CruiseLight,1,==,&&,RPM,2500,>
action = start
conditionrpn = CruiseLight,0,==,||,RPM,2500,<
action = stop
; only log when the engine is running
;conditionrpn = RPM,0,>
;action = start
;
;conditionrpn = RPM,0,==
;action = stop
; start logging to a new file when the throttle goes from previously below 80 to above 80
; #throttle refers to the previous throttle sample
conditionrpn = TPS,80,>,#TPS,80,<=,&&
action = newfile
I'm not sure if it should be this based on the way the other operators are set up:
- Code: Select all
Code:
conditionrpn = CruiseLight,1,==,RPM,2500,>,&&
action = start
conditionrpn = CruiseLight,0,==,RPM,2500,<,||
action = stop