openecu.org

hi, yesterday i modified the timing map on my cs lancer 4g18, i gave +20º on the timing at 4000rpm´s+, and i was monitoring with mitsuloger. now, my question is, does this engine has any knock sensor? because i was watching the knock sum column and it always kept on 0, or is there any other program that detects this knocks?? i also tried evoscan, and the same thing, 0 knock sum. can somebody resolve my question? thanks

yes it has a knock sensor usually located in the block just below the inlet manifold

ok thanks, but why when i run mitsulogger it doesnt gives me any knock at +29º??? is it handling it well or is there any problem?? thanks

i would say normal ,you could use a set of det cans to double check, what afr ?

I would check your knock limit map as well, to ensure that it is not clamping the applied value, though I think you hope it will.

If your methodology is to add that much timing at a load site, without monitoring afr, egt's or actual torque output, you may be hurting you engine for no real gain.

Parts of the load cycle (WOT), I would not recommend adding that magnitude of timing. Being that knock systems are still not perfect, and you do not have a very high compression engine, knock activity may not even be detected at that amount of loading.

Bro.... Your lancer XML is 95250001 or 91210001? Can I know where u from?

my definition is the 91210001, should i try the other one??? if i should, can you send it to me?? thanks!!!

im from Guatemala, Central America