by Zakie@TIC » Wed Oct 17, 2007 7:18 am
The car started (JDM EVO VIII RS) with the two USDM ecu's (MN 13274 & MN 191022) only after flashing the JDM E VII Ralliart map on to both ecu's. After a few minutes of running the MIL comes on with P0135 & P0141, which are O2 heater codes. I must say there is no mil code with the original ecu of this car with the same map flashed.
On flashing the EDM E VII Ralliart map onto these USDM ecu's the P0141 code went away and now I'm left with code P0135 to deal with.
Can I have some help to disable the heater circuit in hex or some other method rather than to hang resistors on the harness bcos I'm hoping to use this ecu on a EVO IV.
Any help will be greatly appreciated.
Regards,
Zakie