2003 USDM Legacy EJ25
Posted: Fri Dec 07, 2012 7:59 pm
I have a Tractix Openport 2.0 with ECUFlash, and it worked good at removing Fault codes (couple of Evap codes and such) on a 2002 WRX ECU/Engine what i've installed into a Replica 356 Porsche.
Is there anyway to do the same on a 2003 USDM Legacy with a NA 2.5L ? Tuning part i don't care about, i just like to be able to remove the Fault codes for systems that are not fully installed (Evaporative Emissions)
Added:
the ECU has a part number 22611-AJ20A, which i found by searching online is a 2004 Legacy ECU, but 2004 Legacy's were DBW? This setup is not. The harness is correct for a 2003 Legacy for Pin-out and even colors, and plug into the ECU no problem either
Any thoughts or ways to make this happen would be wonderful to know
Thank you
Is there anyway to do the same on a 2003 USDM Legacy with a NA 2.5L ? Tuning part i don't care about, i just like to be able to remove the Fault codes for systems that are not fully installed (Evaporative Emissions)
Added:
the ECU has a part number 22611-AJ20A, which i found by searching online is a 2004 Legacy ECU, but 2004 Legacy's were DBW? This setup is not. The harness is correct for a 2003 Legacy for Pin-out and even colors, and plug into the ECU no problem either
Any thoughts or ways to make this happen would be wonderful to know
Thank you