2003 USDM Legacy EJ25

2003 USDM Legacy EJ25

Postby 91 XR7 » Fri Dec 07, 2012 7:59 pm

I have a Tractix Openport 2.0 with ECUFlash, and it worked good at removing Fault codes (couple of Evap codes and such) on a 2002 WRX ECU/Engine what i've installed into a Replica 356 Porsche.
Is there anyway to do the same on a 2003 USDM Legacy with a NA 2.5L ? Tuning part i don't care about, i just like to be able to remove the Fault codes for systems that are not fully installed (Evaporative Emissions)

Added:
the ECU has a part number 22611-AJ20A, which i found by searching online is a 2004 Legacy ECU, but 2004 Legacy's were DBW? This setup is not. The harness is correct for a 2003 Legacy for Pin-out and even colors, and plug into the ECU no problem either

Any thoughts or ways to make this happen would be wonderful to know
Thank you
91 XR7
 
Posts: 6
Joined: Fri Dec 07, 2012 7:02 pm

Return to Subaru (all models)

Who is online

Users browsing this forum: No registered users and 10 guests