openecu.org

Hi ,

Are we able to tune legacy , forester and subaru diesel ?

YES, can tune it,

but not yet with Tatrix 2.0

Best regards


Christian Piasini
R&D Piasiniengienering

And with the 1.3 ?

Can we acces to ecu rom ?

If im not wrong, EDM diesel models are using Bocsh Edc ecu you can read write with Byteshooter unit but ecuflash/romraider doest have that support.
You can tune it with WinOLS Licenced version

Regards
Yuregir

The Subarus Diesel have Denso ecu, not bosch.

and right now Serial suite Piasinienginenring and ECUtek are the only ones device support them.

Best regards


Christian Piasini
R&D Piasiniengeering

Hei,

I heart some rumors, that there´s worked on Tratrix 2.0 doing the Denso ECUs ?

What´s actual state ?

It it true ?
Will there be a a solution with openecu-software for diagnostic, read and flash the Diesel-ECU someday ?

Mazda works with the same ECU, so are there any hinds for deffinitions of maps ?
May I can go for finding interesseting maps, while waiting for a functional flash soltuion

Regrads

Hope you already know, that rumor have a lot, and true things much less.-...



Best regards


CHristian Piasini
R&D Piasineingineering

Not sure about the Mazda's, but there is another tool being developed to work with Subaru / Mitsubishi diesels.
IMHO, the time will come for Tactrix to develop support for Boxer diesel, too.

remapping wrote:but there is another tool being developed to work with Subaru / Mitsubishi diesels.

Christians tool does it and ECKtek is also able to.
If I look at ECUtek-SW optically it is very similar to ECUFlash, so maybe there are some hints to implementate the Diesel-ECU to ECUFlash.

I also hear that ECUedit should work at flashing Diesel-ECU, but this is at this time also just an other roumors..

Maybe you can give us a hint (or me via PN) with tool do you mean ?!

IMHO, the time will come for Tactrix to develop support for Boxer diesel, too.

On request at Tactrix, not in the near future
AFAIK the Diesel-Engines are not offert in the US, so there is no need to implementat then on a US-tool.

Hopefully I´m wrong with this...