while I realise this sounds like a stupid noob problem, the typical noob answers have not given me a solution.
simple story.
2004 wrx sti usdm
I have a 2.0 cable, openecu version 1.38, and can not connect to my ecu.
here is a screen shot of the error log:
I have made sure both sets of green connectors are connected, the car does go into test mode (fans cycle). I have tried all of the timing tricks with ok button /turning the key.
I have also tried to get help from two locals in michigan that can connect their computers to their own cars, but not to mine.
basically at this point I know I have dtc's for 02 sensor and tgv's being removed, I have been able to connect to the obd reader at autozone to get free readings from th port, but not to a tactrix cable.
i was just looking for a simple way to delete some codes, any ideas would help. thanks
[/img]