openecu.org

I finally made the switch to EVOScan but, am having trouble with my LC-1 readings. I am able to connect with the LC-1 through EVOScan, however, the reading is in volts. I enabled the A/F ratio logger as well, which appears to have a calculation to convert the volts to a A/F ratio, however, all that is giving me is a steady 14.7?

I verified the LC-1 was reading correctly via LogWorks.

FYI - I'm using v2.5 EVOScan

Does the LC1 go through ecu or just serial?

I could never choose evoscan over LW since the only OBDII logs I use are timing and knocksum. Just find charts of numbered collumns and logs with same access a limiting feature for capability.