C6ect.ect wrote:Pardon my ignorance on this but are you saying that all I need for WB reading on my EvoScan is:
1) $12 Serial Program Cable (#3746)
2) $199 £ Cable (LC-1 #3769)
3) $10 USB - RS232 cable adaptor
So I just provide a 12VDC input and ground to the Lambda cable which in turn provides the digital communication between Bosch sensor and Evoscan PC?
So approximately $250 plus shipping and a little wire maintenance and I have A:F logging?
Also, would the Evo VIII rear O2 sensor bung accomidate the Bosch sensor threads and location requirement?
Thanks
I just looked at the LC-1 user manual at
http://www.innovatemotorsports.com/supp ... df#page=11 and it indicates the serial program cable is included with the LC-1, so you might not need to order it separately. Confirm with Innovate before ordering.
Assuming the serial program cable is part of the LC-1 package, your total cost would be $199 plus shipping plus the cost of a USB->RS232 converter.
The Bosch sensor will fit in your rear O2 sensor's bung and that'd be a fine place to install it if you have no cats upstream between it and the engine.
BTW, this link contains a list of the wideband A/F meters supported by Evoscan -
http://www.limitless.co.nz/evoscan/.