I have been searching all over many different forums and have read every post that seemes even remotely relevant and cannot figure this out. I have a soo4 wrx that i am trying to flash a new rom to. I have the green connector connected and the white connector plugged in. I am using a tactrix 2.0 cable and ecuflash.
When i test flash the rom it will finish and say that everything is fine but in the middle of the log it says that the programming voltage is 12.64 volts and then it says that the programming voltage is out of bounds. When i try to actually flash the rom it stops and the log says that the programming voltage is 12.64 and the programming voltage is out of bounds then it quits. It does not say anywhere that it is too low or too high.
I have not found any other people to have this problem a lot of people have the too low voltage problem but not this. I am getting quite frustrated and need help
Thanks in advance