Hello,
I am using an Openport 2.0/Tactrix
I have downloaded Download EcuFlash 1.42.2595 for Windows Vista.
I open the base map I have in Ecuflash, open map, plug cable in, connect two cables under the dash together (next to jump cable plug under dash drivers side).
I have never been able to connect to the ECU. The write to ECU tab is never highlighted.
Not sure if this is a driver issue or more. Not sure on how to set them up anyway even though I have downloaded them it does not seem to prompt me to do so anyway.
Any help gladly accepted.
Thank you,
Mark