Not sure if this has been covered elsewhere, but here's a link to what I've been doing
http://forums.openecu.org/viewtopic.php?p=8571#8571
Editted to say : Doh! just spotted a lot more BIN files ealier in this thread.
I have now downloaded these and emailed them home, so will have a look later.
I have an Excel spreadsheet that decodes some of the maps and provides 3D plots. So I will post some examples shortley.
It's the same Excel spreadsheet I used to decode Pre-96 maps, which I have been using to map over 150 cars over the last few years.
So far, everything I have found in the Ae802 ECU uses the same conversion factor to convert from 'Hex' to 'Real' values as the Pre96 ECU maps.
Some of you were talking about the Axis for the Ignition & Fuel Maps. These are RPM and Load based. Load being some sort of MAF caluclation. Normally the load scale runs from about 4 to 45, but thining about this, i f you divide by 10 it could be MAF voltage i.e 4.5V
However, I have only every seen it displayed on graphs around 4 to 45 (different maps have slightly different scales i.e 4 to 43 or 4 to 47). And that includes an HTML output using ECUT*K.
P.S If anyone wants Pre96 BIN or HEX files just shout as I think I have nearly every ECU on disk.