re: map editing

OpenECU software executables and source code

Moderator: Freon

re: map editing

Postby wcassar » Wed Dec 07, 2011 1:38 pm

Hi all, I have installed the ecuflash 1.29a version and yes, I have succeed in connecteing with the evo 7 ecu and read the map.
One problem has arised, I cannot see the map itself.

The user is set to developer already.

regards
wcassar
 
Posts: 14
Joined: Mon Jun 30, 2008 11:49 am
Location: Malta

Re: re: map editing

Postby todd-w » Wed Dec 07, 2011 2:40 pm

you need the xml 98640014 and evo7 base xml most likely should be on here somewhere
todd-w
 
Posts: 330
Joined: Tue Nov 14, 2006 3:01 pm
Location: Ireland

Re: re: map editing

Postby todd-w » Wed Dec 07, 2011 2:51 pm

viewtopic.php?f=55&t=4982&p=24773&hilit=evo7+jdm+definition#p24773


xml above and base xml attached save to rommetdata/mitsi/evo
Attachments
evo7base.xml
(26.21 KiB) Downloaded 921 times
todd-w
 
Posts: 330
Joined: Tue Nov 14, 2006 3:01 pm
Location: Ireland

Re: re: map editing

Postby wcassar » Fri Dec 09, 2011 11:52 am

thats fine i read well and can edit maps....
how can I eliminate the error P0136 error fro periphery?

regards
wcassar
 
Posts: 14
Joined: Mon Jun 30, 2008 11:49 am
Location: Malta

Re: re: map editing

Postby todd-w » Fri Dec 09, 2011 1:29 pm

what car is the ecu running ??
log the front o2 sensor with evoscan make sure its working
todd-w
 
Posts: 330
Joined: Tue Nov 14, 2006 3:01 pm
Location: Ireland

Re: re: map editing

Postby wcassar » Sat Dec 10, 2011 11:03 am

I m running a 4g63 evo 1-3 engine with the evo7 ecu.
wcassar
 
Posts: 14
Joined: Mon Jun 30, 2008 11:49 am
Location: Malta

Re: re: map editing

Postby todd-w » Sun Dec 18, 2011 1:21 pm

is the eng in a 1-3 ???

try disable it in the ecu periphery 2 (FCA) change bit 04 to 0 , something strange there though as a jdm 7 using 98640014 rom never had rear o2 so ecu shouldnt be looking for a signal you can use 90550001 rom ,no rear o2 or immobiliser


ps you certain its not p0135 fr o2 heater circuit
Anyway as you dont have 4 wire o2 change periphery FAA bits bit14 (fr o2 heater circuit ) to 0
todd-w
 
Posts: 330
Joined: Tue Nov 14, 2006 3:01 pm
Location: Ireland


Return to OpenECU Software

Who is online

Users browsing this forum: No registered users and 4 guests