EcuFlash V1.35 Crashes on ROM Read
Posted:
Sun May 18, 2008 1:39 amby Mattjin
Just installed V1.35 (on Vista Business machine) and it refuses to do a ROM Read. It goes past the point where you select vehicle type, then it locks up not respsonding. Re-installed V1.34 and all is working perfectly.
Anyone else having any problems?
Re: EcuFlash V1.35 Crashes on ROM Read
Posted:
Tue May 20, 2008 7:27 amby BoxerFan
If it is 100% CPU hang, I have the same problem.
Posted:
Tue May 20, 2008 5:33 pmby Jon [in CT]
I think you need to explain exactly what you were attempting to do and exactly how far the program got while doing it.
Posted:
Tue May 20, 2008 8:01 pmby blue.taxi
btw, should the released date is 2008?? or is it a back dated ver?
http://www.openecu.org/index.php?title=EcuFlash
Posted:
Tue May 20, 2008 9:18 pmby evo400
Jon [in CT] wrote:I think you need to explain exactly what you were attempting to do and exactly how far the program got while doing it.
OK, if you run program, than select car to dowload rom and it hangs after that. U see only 100% CPU load on system and no comunication with cars ecu. Using 1.3M cable
Posted:
Wed May 21, 2008 1:27 amby BoxerFan
evo400 wrote:OK, if you run program, than select car to dowload rom and it hangs after that. U see only 100% CPU load on system and no comunication with cars ecu. Using 1.3M cable
Exactly the same symptom. Also using 1.3M cable, to read Subaru 32bit ECU.
-> 1.3M cable to read/flash Subaru 32bit works with 1.29.
Posted:
Thu May 22, 2008 2:08 pmby Mattjin
I was trying to read an EVO 7, but it is definitely repeatable.
Exactly what I did. Got the notice in V1.34 that V1.35 is released. Downloaded and installed, but then find the crashing problem. It recognises the cable is there, it lets you select to do a ROM read, you select the vehicle type, then it hangs. Never noticed the CPU usage sorry.
Re-install V1.34 and back to fully operating again.
On a side note for whoever is reading this and has something to do with the software developement. Is it possible to add something to the software to remember where each map is placed on the screen? It remembers while the software is open and each map is opened and closed, but restart the software and you have to go back to re-positioning mulitple maps so you can see them. Minor annoyance.
