openecu.org

by **frankis78** » Tue Dec 12, 2006 12:44 am

Hello
What is the best sw to read and flash a subaru wrx 2003mod car?

ecuExplorer or ecuFlash?

I have just got the tactrix cable now, and like to test it..

Regards

by **Twinturbo** » Tue Dec 12, 2006 1:16 am

I use Ecuflash for reading ecu definitions and flashing and Ecuexplorer for reading trouble codes and resetting CELs. Think that is the easiest way to do it.

by **frankis78** » Tue Dec 12, 2006 2:06 am

Hello
Thanks for replay:)

Can you tell me what you mean with resetting Cells?
Is resetting Cells and clear error codes something you must do after tuning?

Another thing..
Do you need to correct chksumm on ecu like this, after you have modified file :oops:

Its a bit new to me that i can do these ecu by obd.

Regards

by **Twinturbo** » Tue Dec 12, 2006 3:27 am

CEL = Check Engine Light :wink:

And no, you do not have to do that until the CEL starts to annoy you :wink:

I am not sure about the check sum fix, but I think you only need to do that on DBW ecus (2006-).

And you could remove the the trouble codes you do not want to see (in Enginuity)

by **frankis78** » Tue Dec 12, 2006 5:14 am

Hello again twinturbo

Thanks again:)

Do you have any nice file for this car?

Regards

openecu.org

ecuExplorer or ecuFlash

ecuExplorer or ecuFlash

Who is online