OpenPort 1.3M Schematic

OpenECU hardware design documents

Moderator: Freon

Re: OpenPort 1.3M Schematic

Postby radsdau » Fri Sep 14, 2012 5:48 pm

Hexec wrote:So the schematics on the first page is for the 1.3U. What has changed in 1.3U to become OpenPort 2.0? Is the 2.0 schematics available also?

op2 is a totally different animal. It is a full J2534 interface, whereas the 1.x types are pretty much just ush serial ports with a few other features.
Op2 has a powerful micro that has a lot of smarts inside, and the ability to apply varying voltages to a selectionof obdii pins.
Even if you had a schematic for it, it would be of little use (other than for repairing dead parts), as all the good stuff is software.
radsdau
 
Posts: 674
Joined: Wed Feb 08, 2006 6:56 pm

Re: OpenPort 1.3M Schematic

Postby Hexec » Fri Sep 14, 2012 9:24 pm

Thank you, that makes sense. After going to tactrix website, it listed out what it was able to do. Nice device.
Hexec
 
Posts: 10
Joined: Mon Sep 10, 2012 10:16 pm

Previous

Return to OpenECU Hardware

Who is online

Users browsing this forum: No registered users and 8 guests