Page 1 of 1

EcuFlash v1.30 "Couldn't communicate with OpenPort"

PostPosted: Sat Mar 10, 2007 9:17 pm
by Evo4Mad
I am getting this error with EcuFlash.
"Couldn't communicate with OpenPort"

on an Tactrix OpenPort v1.0, OpenPort v1.2, OpenPort v1.3M tactrix cables, but the Tactrix OpenPort 1.3U seems to work fine. Any ideas?

PostPosted: Tue Jun 24, 2008 7:17 am
by themadscientist
Bump

I am having the same problem. After installing ECUflash 1.30 my Openport 1.2 is not recognized even after uninstalling 1.30 and reinstalling 1.28.

Re: EcuFlash v1.30 "Couldn't communicate with OpenPort&

PostPosted: Wed Jun 25, 2008 8:46 pm
by BoxerFan
Evo4Mad wrote:I am getting this error with EcuFlash.
"Couldn't communicate with OpenPort"

on an Tactrix OpenPort v1.0, OpenPort v1.2, OpenPort v1.3M tactrix cables, but the Tactrix OpenPort 1.3U seems to work fine. Any ideas?


Am also having same problem of unable to use ecuFlash 1.3X with OP1.3M on Subaru vehicle. Suspect problem with ecuFlash 1.3X program, probably does some checking of the cable type....

Workaround is to use ecuFlash 1.29.