EcuFlash v1.30 "Couldn't communicate with OpenPort"

OpenECU hardware design documents

Moderator: Freon

EcuFlash v1.30 "Couldn't communicate with OpenPort"

Postby Evo4Mad » Sat Mar 10, 2007 9:17 pm

I am getting this error with EcuFlash.
"Couldn't communicate with OpenPort"

on an Tactrix OpenPort v1.0, OpenPort v1.2, OpenPort v1.3M tactrix cables, but the Tactrix OpenPort 1.3U seems to work fine. Any ideas?
Evo4Mad
 
Posts: 332
Joined: Mon Jun 13, 2005 11:58 pm
Location: New Zealand

Postby themadscientist » Tue Jun 24, 2008 7:17 am

Bump

I am having the same problem. After installing ECUflash 1.30 my Openport 1.2 is not recognized even after uninstalling 1.30 and reinstalling 1.28.
themadscientist
 
Posts: 1
Joined: Mon Jan 24, 2005 9:06 am

Re: EcuFlash v1.30 "Couldn't communicate with OpenPort&

Postby BoxerFan » Wed Jun 25, 2008 8:46 pm

Evo4Mad wrote:I am getting this error with EcuFlash.
"Couldn't communicate with OpenPort"

on an Tactrix OpenPort v1.0, OpenPort v1.2, OpenPort v1.3M tactrix cables, but the Tactrix OpenPort 1.3U seems to work fine. Any ideas?


Am also having same problem of unable to use ecuFlash 1.3X with OP1.3M on Subaru vehicle. Suspect problem with ecuFlash 1.3X program, probably does some checking of the cable type....

Workaround is to use ecuFlash 1.29.
BoxerFan
 
Posts: 58
Joined: Fri Aug 12, 2005 5:56 am
Location: Southeast Asia (little red dot)


Return to OpenECU Hardware

Who is online

Users browsing this forum: No registered users and 8 guests

cron