Page 1 of 1

interface close error

PostPosted: Sun Mar 03, 2013 12:47 am
by ddammitt
Hi everyone first time poster after a little advice. I am trying to read and download ecu of my 2004 Forester 5MT (Australian) using ecuflash and tactrix usbcable but every time I try to read ecu I get 'error see log'. Pic attached. I have read a ton of solutions and ideas and tried:

Reinstalling, Putting in compatibility mode, running as administrator, connected green test mode cables, even tried to jump the white flash block which only has two wires/connection points. Pic attached. I have tried different computer. I also press 'ok' when I turn key to on position (Tried about 100 different methods of this)

Anyone have any advice or can tell me what I am doing wrong?

Thanks in advance guys.

photo.JPG
photo.JPG (112.57 KiB) Viewed 8819 times

screen.jpg
screen.jpg (188.01 KiB) Viewed 8819 times

Re: interface close error

PostPosted: Tue Mar 05, 2013 2:48 am
by ddammitt
Anyone have any ideas?

Re: interface close error

PostPosted: Wed Mar 13, 2013 8:21 am
by mporeda
What model Forester do you have (NA or turbo)? Can you just copy and paste the logging output in to your reply? The screen shot misses a lot of what we need to see.

Re: interface close error

PostPosted: Thu Mar 14, 2013 12:53 am
by martymonaro
Maybe it has been tuned with ecutek or cobb?